9 knowledge points in the use of aluminum plates
1. Aluminum plate storage: Store the plate in a dry and ventilated place, and place it flat on a flat surface. Do not step on it or hit it.
2. Aluminum plate handling: When transporting the plate, the four sides of the plate should be lifted at the same time. Pushing, pulling, and extraction are strictly prohibited to avoid scratching the surface of the plate.
3. Aluminum plate slotting: When slotting with a slotting machine or a gong machine, a milling cutter with a semi-round head type greater than 90 degrees should be used. There are 0.2-0.3MM thick plastic core materials and aluminum plates that are bent together to increase strength and toughness, otherwise the aluminum plate may break or the paint film may burst during bending.
4. Bending of aluminum plate: When bending, uniform force is required, forming at one time, do not bend repeatedly, otherwise the aluminum plate may break.
5. Aluminum plate arc processing: special bending equipment should be used to process the arc, and the force should be applied slowly to make the plate gradually reach the required curved surface. Do not bend it at one time.
6. Batches of aluminum plates: There may be color difference between plates of the same model but different batches. When selling and using different batches of plates, the procedure of comparing color differences should be added. Our company mainly deals in alloy aluminum plates, aluminum pattern plates, etc., when there is no visual color difference can be used on the same plane.
7. Installation direction of the aluminum plate: When installing the same color aluminum plate on the same plane, the process direction should be consistent, otherwise it may cause visual chromatic aberration.
8. Aluminum plate tearing film: The protective film should be torn off within 45 days after the aluminum plate is installed, otherwise it may be difficult to tear the film or remove the glue.
9. Conditions of use of aluminum panels: interior wall panels should be used indoors, and should not be installed outdoors, so as to ensure the use effect and service life.
2. Aluminum plate handling: When transporting the plate, the four sides of the plate should be lifted at the same time. Pushing, pulling, and extraction are strictly prohibited to avoid scratching the surface of the plate.
3. Aluminum plate slotting: When slotting with a slotting machine or a gong machine, a milling cutter with a semi-round head type greater than 90 degrees should be used. There are 0.2-0.3MM thick plastic core materials and aluminum plates that are bent together to increase strength and toughness, otherwise the aluminum plate may break or the paint film may burst during bending.
4. Bending of aluminum plate: When bending, uniform force is required, forming at one time, do not bend repeatedly, otherwise the aluminum plate may break.
5. Aluminum plate arc processing: special bending equipment should be used to process the arc, and the force should be applied slowly to make the plate gradually reach the required curved surface. Do not bend it at one time.
6. Batches of aluminum plates: There may be color difference between plates of the same model but different batches. When selling and using different batches of plates, the procedure of comparing color differences should be added. Our company mainly deals in alloy aluminum plates, aluminum pattern plates, etc., when there is no visual color difference can be used on the same plane.
7. Installation direction of the aluminum plate: When installing the same color aluminum plate on the same plane, the process direction should be consistent, otherwise it may cause visual chromatic aberration.
8. Aluminum plate tearing film: The protective film should be torn off within 45 days after the aluminum plate is installed, otherwise it may be difficult to tear the film or remove the glue.
9. Conditions of use of aluminum panels: interior wall panels should be used indoors, and should not be installed outdoors, so as to ensure the use effect and service life.